This is TAG Hardware's own photo.
Closet Rod End Support, Synergy Elite Collection
Slate
1.25" wide, 1.25" deep
Unique two-part design allows the support to fully surround the rod ends. With two pins for 5 mm (3/16") holes. Side supports connect to the wedge shaped brackets. 32 mm (1 1/4") spacing with an additional screw hole for side panel mounting. Material: Zinc alloy. Installation: Connect the wedge shaped brackets into line bore holes and side supports onto the end of the rod, then slide supports onto the wedge shaped brackets.
Each.
What it fits
Tell us the cabinet and we will check the fit before you order.
- Its size
- 1.25" wide, 1.25" deep
- TAG Hardware says
- TAG Synergy Elite Collection.
- Connect the wedge shaped brackets into line bore holes and side supports onto the end of the rod, then slide supports onto the wedge shaped brackets.
Measure inside the cabinet opening, then compare it with the opening it needs.
Goes well with it
Goes with it, sold separately: Zip-R Screw, Flat Countersunk Head, #2 Phillips Drive, with Nibs.
Goes with it, sold separately: Zip-R Screw, Flat Countersunk Head, #2 Phillips Drive.
Goes with it, sold separately: Zip-R Screw, Flat Countersunk Head, #2 Square Drive.
Goes with it, sold separately: Round Closet Rod, Synergy Elite Collection.
What you are getting
- Checked against our cabinets, so you know before you buy what it fits
- About a week to get here
- We can put it in when we install your cabinets